skip to content »

ik-kem.ru

Windows xp time not updating domain

windows xp time not updating domain-74

If this message appears again, contact your system administrator. The short story is that somehow there is a computer account password mismatch. You’ll be prompted to enter the credentials of a user with administrative rights. Download details: Windows Server 2003 Service Pack 1 32-bit Support Tools

windows xp time not updating domain-47windows xp time not updating domain-42

For your comfort, this page is excellent to start with.The flag "0x8" forces w32time not to send "symmetric active" packets but normal "client" requests which the NTP server replies to as usual.Then the following command can be used to immediately make the changes effective: If this command has completed successfully your system clock has synchronized to the given NTP server.To make any w32time changes in command line window one has to run cmd program as administrator (see Figure 4).The actual IP address of the NTP server or its host name must be entered instead of [server].In the Service status click on the "Start" button to start the time service. A great deal of synchronization problems may be caused by network break downs, unpredicted traffic delays, unknown accuracy and public NTP servers where you don't have control over.

Although public time service may be cost free, but 24/7 operation, accuracy and customer support in case of a failure is not guaranteed.

It is also perfect to use at home to collect logs and to get visibility of your home network.

If you also install xpack you will get a function called “watcher”. When I set this up in a lab recently I found out that it was not that easy to get started so I decided I should share what I found out.

w32time sends namely symmetric active instead of client mode packets to a NTP server.

This problem has not been observed with the w32time version which has been shipped with Windows 2000, only with later versions.

Because of this, the computer cannot authenticate itself to the domain controller(s), and thus you get this error. Method #1 – Using the GUI This method may be the easiest one to perform, and it requires a double reboot of the client computer.